Frequently Asked Question

Suitable for the cameras that support SD card, such as the following models: FI9818W V2, FI9821W V2, FI9821P, FI9821E, FI9821EP, FI9826W, FI9826P, FI9831W, FI9831P, FosBaby, FI9803EP, FI9853EP, FI9821W V2.1, FI9821P V2, FI9826P V2, FI9831P V2, FI9816P

In order to store the alarm images to the SD card, please follow the 3 steps below to configure your camera.

Step 1:
Insert a SD card

Please insert a SD card and make sure it is recognized. Besides, please make sure it can be read and write.


Step 2:
Setup the Motion Detection Settings

Please go to Settings-->Alarm-->Motion Detection menu (refer to Picture 2) ① Click “Enable” first,② choose “Take Snapshot” for the alarm action, ③ set your detection area, and ④ set your schedule. Do not forget to click “Save” button.

Note:
1. Please DO NOT forget to set the alarm schedule, no schedule no alarm;
2. Please make sure your camera time is correct
3. Please DO NOT forget the set the alarm area, the detected area should be covered by the red grids.

Step 3:
Setup the Storage Location

Please choose “SD card” on the “Picture Save to” dropdown list.

Well, if there is motion trigger, camera will alarm and you can receive alarm images in your SD card.