Frequently Asked Question
HD: How can I upload alarm images onto my FTP server?
Last Updated 9 years ago
In order to upload the alarm images to the FTP, please follow the 3 steps below to configure your camera.
Step 1 : Setup FTP Settings
Please go to Settings-->Network-->FTP Settings menu, and configure your FTP settings there.
Picture 1
Note:
1.Please click on “Save” before you click on “Test”;
2.Make sure the test result is success.
Step 2 : Setup the Motion Detection Settings
Please go to Settings-->Alarm-->Motion Detection menu. Refer to Picture 2, → click “enable” first, → choose “Take Snapshot” for the alarm action,→ set your detection area , and → set your schedule.
Picture 2
Remember to click on “Save” after you finish settings.
Note:
1.Please DO NOT forget to set the alarm schedule, the alarm schedule is red.
2.Please make sure your camera time is correct.
3.Please DO NOT forget the set the alarm area, the detected area is covered by the red grids.
Step 3 : Setup the Storage Location
Please choose “FTP” on the “Picture Save to” dropdown list.
Picture 3
End
Step 1 : Setup FTP Settings
Please go to Settings-->Network-->FTP Settings menu, and configure your FTP settings there.
Note:
1.Please click on “Save” before you click on “Test”;
2.Make sure the test result is success.
Step 2 : Setup the Motion Detection Settings
Please go to Settings-->Alarm-->Motion Detection menu. Refer to Picture 2, → click “enable” first, → choose “Take Snapshot” for the alarm action,→ set your detection area , and → set your schedule.
Remember to click on “Save” after you finish settings.
Note:
1.Please DO NOT forget to set the alarm schedule, the alarm schedule is red.
2.Please make sure your camera time is correct.
3.Please DO NOT forget the set the alarm area, the detected area is covered by the red grids.
Step 3 : Setup the Storage Location
Please choose “FTP” on the “Picture Save to” dropdown list.
End
ZGTLv151102